Hi all,I am finally happy to release my plugin for the Huanyang VFD to the world.This plugin has been written for use with the Huanyang series of Variable Frequency Drives (VFD). It allows Mach3 to control the operation of the VFD via RS485 communication port.The plugin incorporates the following features. Stop & Stop Spindle. Set desired spindle RPM. Monitor actual spindle RPM. Monitor current draw of spindle. Triggers ‘Stop’ or ‘E-Stop’ event if commands to VFD fail.If you have any problems using this plugin please post them here.
However please limit it to problems directly relating to the plugin. If you having difficulty seting up the VFD for manual control there are far better places to get help (CNCZone).Please let me know if you find this plugin useful:-)A big thanks goes to Mark Hastings for helping me test this and giving me a prod now and then to get this finished. First off all thanks for the effort of making this plugin. First off all thanks for the effort of making this plugin.
The Huanyang VFD and Hallmark motor were free to me so I will be using these for the first go. If I am not satisfied with the performance I will upgrade to better equipment later. Here are the VFD and motor labels. First I want to verify I have the base wiring done correctly. The VFD is 220v so I have the motor wired in the 'Low Volt.